Admin Verification is a process of establishing a controlled state of your network,
or the devices which you are monitoring with IntraVUE.
Each Admin Verified node has different characteristics from a non-Verified node.
the node is normally blue filled
if the position of the device changes, the verified position becomes red filled.
the actual position of the device becomes a tan filled node
When all the devices in a network are verified, the nodes in IntraVUE will all be blue.
Some may have yellow or red connecting lines, or even red outlines, but you will
basically be looking at all blue boxes.
To make Admin Verification easy, there is a single button that will automatically
verify every device with an IP address that has not yet been verified. It on the
Scanner Tab of the System Configuration dialog
When a box is tan it will stand out. It will call your attention to it.
Find out what it is and then verify it or take some action to get the device off line.
A red filled node is the 'ghost' of the real position of a device.
In IP View the real device will have a real IP name like 10.1.100.56 and in the
red filled box the IP will be 10-1-100-56.
If you see a red filled box, find the corresponding tan filled box.
If the new position is acceptable, delete the red filled box and admin verify the
new position. In the future this two step process will become one step.
If the position is temporary you may leave the red filled box. When the device
is returned to its former position the red box will be replaced by a blue filled box.